单项选择题

What is the function of the no switchport catalyst switch interface configuration command?（）

A. Disables the interfaces to prevent traffic flow
B. Clears all the configurations on the interface
C. Switches the port from access mode to trunk mode
D. Converts the port from physical Layer 2 port to physical Layer 3 port

点击查看答案

上一题目录下一题

相关考题

单项选择题

What is the maximum number of Cisco Catalyst 3750 Series Switches that can be united into a single manageable unit using the Cisco StackWise technology?（）

A.9
B.3
C.12
D.6

单项选择题

As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）

A. using DHCP snooping
B. snooping the incoming 802.1Q VLAN tag
C. using CDP
D. snooping the CoS marking on the incoming frames

单项选择题

What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）

A. Route reflectors are not passing updates properly.
B. BGP synchronization has been enabled.
C. The next-hop address is unreachable.
D. No loopback interface has been configured on a router.