多项选择题

The network administrator is trying to add Switch1 to the network， but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem？（）

A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q.

点击查看答案

上一题目录下一题

相关考题

问答题

What is the PMTUD for IPv6 network？

问答题

what is a route reflector？

多项选择题

Refer to the exhibit. Two ISPs have decided to use MSDP and configured routers X and Y (both are PIM RPs) as MSDP peers. In the domain of ISP B, PC A has sent an IGMP membership report for the group 224.1.1.1 and PC B has sent an IGMP membership report for the group 224.5.5.5. Assuming that the MSDP peering relationship between routers X and Y is functional, and given the partial configuration output shown from router X, which two of these statements are true?（）

A.Router X will contain an entry for 224.1.1.1 in its SA cache and will also have an installed （S，G） entry for this in its mroute table.
B.Router X will not contain an entry for 224.1.1.1 in its SA cache but will have an installed （*，G） entry for this in its mroute table.
C.Router X will not contain an entry for 224.5.5.5 in its SA cache but will have an installed （S，G） entry for this in its mroute table.
D.Router X will not contain an entry for 224.5.5.5 in its SA cache but will have an installed （*，G） entry for this in its mroute table.
E.Router X will have no entries for 224.5.5.5 in neither its SA cache nor in its mroute table.
F.Router X will have no entries for 224.1.1.1 in neither its SA cache nor in its mroute table.

The network administrator is trying to add Switch1 to the network， but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem？ （）

相关考题

The network administrator is trying to add Switch1 to the network， but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem？（）