Your network contains an Active Directory domain named contoso.com.
The domain contains an organizational unit (OU) named OU1 as shown in the OU1 exhibit.(Click the Exhibit button.)

The membership of Group1 is shown in the Group1 exhibit. (Click the Exhibit button.)

You configure GPO1 to prohibit access to Control Panel. GPO1 is linked to OU1 as shown in the GPO1 exhibit. (Click the Exhibit button.)

Select Yes if the statement can be shown to be true based on the available information; otherwise select No. Each correct selection is worth one point.

You have a server named Server1 that runs Windows Server 2012 R2.
You need to create a new volume on Server1.
The new volume must have the following configurations:
Be stored on a new virtual hard disk
Be assigned the drive letter G
Have the NTFS file system
In which order should you run the Diskpart commands?
To answer, move all the Diskpart commands from the list of commands to the answer area and arrange them in the correct order.

Your network contains three servers. The servers are configured as shown in the following table.

Your company plans to standardize all of the servers on Windows Server 2012 R2.
You need to recommend an upgrade path for each server.
The solution must meet the following requirements:
Upgrade the existing operating system whenever possible.
Minimize hardware purchases.
Which upgrade path should you recommend for each server?
To answer, drag the appropriate upgrade path to each server in the answer area. Each upgrade path may be used once, more than once, or not at all.

You have a server named Server1 that runs a Server Core installation of Windows Server 2012 R2.
Server1 is configured to obtain an IPv4 address by using DHCP.
You need to configure the IPv4 settings of the network connection on Server1 as follows:
IP address: 10.1.1.1
Subnet mask: 255.255.240.0
Default gateway: 10.1.1.254
What should you run?（）