单项选择题

You are configuring a Cisco multilayer switch for the Company network.
Which command would you use to configure a port to act as a routed interface？（）

A. ip routing
B. switchport mode trunk
C. no switchport
D. switchport trunk native vlan 1
E. None of the other alternatives apply

点击查看答案

上一题目录下一题

相关考题

多项选择题

Which of the following could be used to provide a Layer 3 data path between separate VLANs？（）

A. VLAN trunking
B. An external router
C. An internal route processor
D. VLAN capable bridge
E. EtherChannel

多项选择题

Inter-VLAN routing has been implemented in the Company network. In VLAN routing，
what are some of the disadvantages of designing a router-on-stick configuration？（）

A. InterVLAN routing cannot be filtered by the router.
B. The router becomes a single point of failure for the network.
C. Routers will not route STP BPDUs.
D. There is a possibility of inadequate bandwidth for each VLAN.
E. Additional overhead on the router can occur.
F. NetFlow Switching is required for InterVLAN accounting.

单项选择题

The Company network needs to pass traffic between VLANs.
Which device should be used to accomplish this？（）

A. Hub
B. Switch
C. Router
D. Bridge
E. None of the other alternatives apply

You are configuring a Cisco multilayer switch for the Company network. Which command would you use to configure a port to act as a routed interface？（）

相关考题

You are configuring a Cisco multilayer switch for the Company network.
Which command would you use to configure a port to act as a routed interface？（）