单项选择题

In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicast traffic to a group？（）

A.The source must send a PIM Register message to the rendezvous point （RP）
B.The source must first join the multicast group using IGMP before sending
C.The source must perform a Request to Send （RTS） and Clear to Send （CTS） handshake with the PIM designated router （DR）
D.No control plane signaling needs to be performed；the source can simply begin sending on the local subnet

点击查看答案

上一题目录下一题

相关考题

单项选择题

Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correct BGP session endpoint addresses and the correct BGP session hop-count limit （EBGP multihop）. What is a good first test to see if BGP will work across the firewall？（）

A.Attempt to TELNET from the router connected to the inside of the firewall to the router connected to the outside of the firewall. If telnet works， BGP will work， since telnet and BGP both use TCP to transport data.
B.Ping from the router connected to the inside interface of the firewall to the router connected to the outside interface of the firewall. If you can ping between them， BGP should work， since BGP uses IP to transport packets.
C.There is no way to make BGP work across a firewall without special configuration， so there is no simple test that will show you if BGP will work or not， other than trying to start the peering session.
D.There is no way to make BGP work across a firewall.

单项选择题

While deploying a new switch， you accidently connect ports 3/12 and 3/18 together， creating a loop. STP detected it and placed port 3/18 in blocking mode. Why did STP not place port 3/12 in blocking mode instead？（）

A.Port 3/12 was already up and forwarding before the loop was created.
B.Port priority is based on lowest priority and lowest port number.
C.You connected the wire on port 3/18 last.
D.None of the above， it is purely random.

单项选择题

Refer to the exhibit. This exhibit shows the NAT configuration for Router A and the output for a ping issued from device 171.68.200.48 and destined to 172.16.47.142. Based on this information, what change must be made to Router A in order for the ping to work?（）

A.reload the router
B.clear the route cache
C.add a static route
D.configure IP as classless
E.load a newer IOS image